Short Rod Piston with long rod compensated pin height?

[81cr450]

Like the title says, Short Rod Piston with long rod compensated pin height? Anybody make one? Any demand? Its like $1000 or $2000 buy in for custom pistons aint it? Or are custom rods cheaper?

Cylinder spacers are ...

Also can I just change the clutch pushrod from a newer motor & add the bearing? On an 86 of course

[Roostius_Maximus]

the bearing will not fit behind the pressure plate of a narrow basket setup, likely the only reason they went to the wide one.
no to the pin height, too much skirt thrust if its moved.

[81cr450]

too much skirt thrust if its moved

Never thought of that, just that banshee s & 250r raise the pin height for longer rods seemed like a good idea.

Skirt thrust does sound like it could be fun though