My buddy Sam is building a gen 1 with an 88 engine from spare parts he and I have.
He's asking me about the swingarm bolt and the water pump outlet.
Anybody have some advice?
Gen 1 with 88 engine
- Roostius_Maximus
- Site Admin
- Posts: 4641
- Joined: November 16th, 2007, 3:24 pm
- Location: Mt Nebo, Manitoba, Canada
- Contact:
Danny Graves had exactly that combo. A longer hose avoided the low style pipe and rear bushings were made for the cases. you can put any 1989+ 125/250/500 case bushings in those if you drill them, some guys have done this. I set the engine on the mill and bore them so its true.
http://www.youtube.com/user/500bigbore
My CR500 Tech Reference... http://sdrv.ms/1a0CIiz
MRE Components... http://sdrv.ms/1bs2zhd
My CR500 Tech Reference... http://sdrv.ms/1a0CIiz
MRE Components... http://sdrv.ms/1bs2zhd
Would it be easier to just put a more modern right case cover on and run the hose up over and down to the waterpump?
The wp cover is cracked and the angled hose connection shows some corrosion so we don't know if it's bad yet.
btw-We both had all this stuff laying around.
He had a '98 AF frame with everything but the front end and wheels, as well as the 500 engine in a steelie.
I had a '97 steelie front end and a PC pipe.
We didn't realize how easy the gen 1 is to convert, with no "Y" to move.
He didn't get a radiator either so, it's a hunt for a stock one or?
The wp cover is cracked and the angled hose connection shows some corrosion so we don't know if it's bad yet.
btw-We both had all this stuff laying around.
He had a '98 AF frame with everything but the front end and wheels, as well as the 500 engine in a steelie.
I had a '97 steelie front end and a PC pipe.
We didn't realize how easy the gen 1 is to convert, with no "Y" to move.
He didn't get a radiator either so, it's a hunt for a stock one or?
I was able to make the old style water pump work with a copper 90, and the stock 80's cr 500 hoses. I can't seem to get a picture up with my phone right now though.
Yah, I'm from Saskatchetoon!
MRE 02 250/500 conversion, pulse injector, twirp porting, coolhead, MRE ignition, blah blah blah blah... www.millarengines.com
MRE 02 250/500 conversion, pulse injector, twirp porting, coolhead, MRE ignition, blah blah blah blah... www.millarengines.com
Half way down page 2 is my nig-guyver hose set up.
http://www.bannedcr500riders.com/board/ ... c&start=25
http://www.bannedcr500riders.com/board/ ... c&start=25
Yah, I'm from Saskatchetoon!
MRE 02 250/500 conversion, pulse injector, twirp porting, coolhead, MRE ignition, blah blah blah blah... www.millarengines.com
MRE 02 250/500 conversion, pulse injector, twirp porting, coolhead, MRE ignition, blah blah blah blah... www.millarengines.com