1. Motor seems like its in good shape, fires on the 1st or 2nd kick cold. No boggs, carb feels close for now.
2. The frame has minimal rust, and not alot of wear in the usual boot area.
3. Wheels are fairly straight, brand new tires. Hubs, rims and spokes show a little age, nothing bad.
4. The front brake, while stopping descent feels little hard at the lever...bleed it?
5. Bars are bent...suggestions?
6. The rear shock is seeping oil..suggestions?
7. The right had rad shroud is sitting on the pipe, a Pro C. It hits the pipe on the corner. Is this a jacked up shroud? Im not in love with the pipe, its been welded nearest the shifter lever. I was thinking of a Gnarly. Would a new pipe cure that? Or shroud, the ones on aren't in the best shape, and I could just knife the corner?
8. The 3 small screw holes on the fork lower casting, that holds the slider guards, 2 on one side are stripped, 1 on the other side is stripped. 1 had teflon tape wrapped aroung the threads, Im guessing to help hold it in. Ideas?
She does run like a raped ape though
The vent/drain hoses on the carb are all dried, will a autoparts store stock that tubing?
