Anybody have a 500 crank sitting around they could measure for me? I need to know the diameter of the crank wheels and the width of the assembled crank.
Wheelie-Gene wrote:Is someone thinking of putting a 500 crank into a 480 (is that possible???)?
I am trying to put one in my 480.. so far I know that I will have to machine a bushing to house the ignition side crank seal, and possibly turn down the crank wheel outer diameter.. I really want my 480 to have a full circle crank.. I am also hoping the 3mm stroke increase will reduce my exhaust duration some to get my timing back where I wanted it to be..
Wheelie-Gene wrote:Did you get the specs that you needed?
somewhat.. I still need a different width measurement. The crankwheels on the 500 according to the measurement above are larger than those of the 480..
Wheelie-Gene wrote:I have a 500 crank setting on my work bench.
I'll see if I can get the measurements that you need, asap.
Does your crank have the tinned wheels? I would like to know the diameter of cranks with and without the tin.. as well as a width measurement of a assembled crank taken at the outside of the wheels