wrist pin bearing

Papagyo · Post by **Papagyo** » January 29th, 2012, 10:45 am

Hi all,

Just a quick question, when doing a routine rebuild going .5mm over is it needed to replace the wrist pin bearing every time or can the old be used? I know it's only fifteen bucks but I would have to wait another week for the part to show up since they have none local in our small town.

Brian

Post by **AlisoBob** » January 29th, 2012, 11:09 am

I reused them before.... never a issue.

Inspect it closely...

I've never reused the clips however...

2strokeforever · Post by **2strokeforever** » January 29th, 2012, 8:12 pm

im kinda sketched about circlips, i always install the gap up or down and they almost never come out that way

re used many wristpin bearings, never a problem

Papagyo · Post by **Papagyo** » January 29th, 2012, 8:24 pm

Thanks guys, I will reuse the bearing and I do have new clips to use.

Brian

seanmx57 · Post by **seanmx57** » January 30th, 2012, 10:27 am

I've got a few new extras in the package. I could send ya one. It would be anywhere in the USA in 3 days at the most.

I've never had one fail, then again I've never reused them either.

Papagyo · Post by **Papagyo** » January 30th, 2012, 12:21 pm

seanmx57,

I will take one then, just give me a paypal address and I will send shipping and the cost you want for the beariing to:

Brian Hooge
1352 Cottonwood Circle
Sheridan WY, 82801

seanmx57 · Post by **seanmx57** » January 30th, 2012, 12:33 pm

Good timing, I'm heading to the post office in a few.

seanmx57@yahoo.com

Look up the price on the web and add $5.

Glad to help.

seanmx57 · Post by **seanmx57** » January 30th, 2012, 12:35 pm

I bet Service Honda has em right in stock.........

Papagyo · Post by **Papagyo** » January 30th, 2012, 12:56 pm

Sean,

Money sent, thanks.

Brian

BannedCR500Riders.com

wrist pin bearing

wrist pin bearing

bearing