Updating Tail section on CR 500 with CR 250 1992-1996
-
- Posts: 444
- Joined: February 12th, 2008, 6:19 am
Updating Tail section on CR 500 with CR 250 1992-1996
I had an old article where if you want a thinner rear section on 1989-2001 CR 500 you can install a complete sub frame airbox SEAT AND FENDER FROM A 1992-1996 cr 250 BUT YOU HAVE TO WELD ONE BOLT TAB ON FRAME FOR SUB ALIGNMENT.
Dirt Rider March '96, the Pro Circuit built CR500 for Rich Taylor. I'm guessing that's the "article" you're mentioning?
The benefits of this are really aesthetic only. Especially for trail riding...you want that soft couch to sit on. But maybe a good face lift for the die hard steely rider?
The benefits of this are really aesthetic only. Especially for trail riding...you want that soft couch to sit on. But maybe a good face lift for the die hard steely rider?
'03 CR500 powered by...umm...a new motor?
Re: Updating Tail section on CR 500 with CR 250 1992-1996
I think I'm just going to use a fine tooth saw to trim mine down this weekend. I will post up.
I'd rather be hauling ass