headstays, engine mounts, etc.
- dannygraves
- Posts: 8020
- Joined: June 1st, 2007, 2:03 pm
- Location: Las Vegas, NV
dude...you are the MAN! thanks.
On another note...I have costing back on the ignition and clutch covers (see earlier posts in this thread for lots of examples) and it looks like the prices will be as follows for 20 pieces:
$150 for an anodized ignition cover with machined-in script (still undecided):
and $175 for an anodized clutch cover with machined-in script (still undecided):
But, I will need to get some orders to offset the costs, or this is a no-go. So, who wants/needs bling?
On another note...I have costing back on the ignition and clutch covers (see earlier posts in this thread for lots of examples) and it looks like the prices will be as follows for 20 pieces:
$150 for an anodized ignition cover with machined-in script (still undecided):
and $175 for an anodized clutch cover with machined-in script (still undecided):
But, I will need to get some orders to offset the costs, or this is a no-go. So, who wants/needs bling?
CR500AC widget maker
It was, although at this point I am not totally sure by how much. After I get the first artical set made, I'll know for sure. My guess is probably something like up to 900ml...but that's just a guess.AlisoBob wrote:On the clutch side, was capacity increased?
Any chance you can post a sticky poll on this subject to see if the membership here wants something other than the script I have already modeled? I think the clutch side is pretty cool as shown, but I could be alone on that one (per Danny's comments). I also think the 1/2 LITER 4 STROKE EATER is cool on the ignition side, but again, I am open for suggestions....for a while. Then, depending on timing, it will be go-time! LOL.
Jay: I won't need the money until we know we are committing to the run...so I guess it might be a little while until we see how many might actually wanna spend some cash.
CR500AC widget maker
OK dudes...I have a couple of sets of two-piece heads stays for gen. one and gen. three. I need a couple of volunteers to test-fit them for me so I know they are spot on before I do a big run. FYI: we went with aluminum, not steel.
Also, I will have the first article clutch and ignition covers done in two days. I may just send those to Bob for test fitment...
Getting closer!
Also, I will have the first article clutch and ignition covers done in two days. I may just send those to Bob for test fitment...
Getting closer!
CR500AC widget maker
-
- Posts: 1898
- Joined: June 23rd, 2007, 12:47 pm
- Location: Prescott
- dannygraves
- Posts: 8020
- Joined: June 1st, 2007, 2:03 pm
- Location: Las Vegas, NV
- dannygraves
- Posts: 8020
- Joined: June 1st, 2007, 2:03 pm
- Location: Las Vegas, NV
- dannygraves
- Posts: 8020
- Joined: June 1st, 2007, 2:03 pm
- Location: Las Vegas, NV
-
- Posts: 1898
- Joined: June 23rd, 2007, 12:47 pm
- Location: Prescott
- dannygraves
- Posts: 8020
- Joined: June 1st, 2007, 2:03 pm
- Location: Las Vegas, NV
- dannygraves
- Posts: 8020
- Joined: June 1st, 2007, 2:03 pm
- Location: Las Vegas, NV