I am back with a 1983 CR480
Posted: July 29th, 2015, 9:31 pm
I picked up a project 1983 CR480.
First question will a Ignition system from a 1997 CR250 fit in to the 480 cases and work.
I know the Ignition on the right hand side so it will be spinning backwards.
Is there anyone make a Mid to Top end pipe for this bike.
And anyone knows where to get new Plastic for this bike that reasonable price just about everything I found so far is expensive.
Can I powder coat the engine cases and I not sure if I can powder coat the Cylinder and Head.
First question will a Ignition system from a 1997 CR250 fit in to the 480 cases and work.
I know the Ignition on the right hand side so it will be spinning backwards.
Is there anyone make a Mid to Top end pipe for this bike.
And anyone knows where to get new Plastic for this bike that reasonable price just about everything I found so far is expensive.
Can I powder coat the engine cases and I not sure if I can powder coat the Cylinder and Head.